The interface cable is not correctly connected. Factory Setting Mode Bit: Soak a small amount of either ethyl alcohol or isopropyl alcohol into a clean, unused Dust-Free Cotton Pad which has been folded over into quarters. Touch [Soft SW Set]. Changing Soft Switch Settings
| Uploader: | Zulkilrajas |
| Date Added: | 2 July 2008 |
| File Size: | 59.14 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 97631 |
| Price: | Free* [*Free Regsitration Required] |
Warm Restart Procedure List Of Network Settings Remove the 2 cables from the cable clamp.
Konica Minolta Pie Manuals
Changing soft switch settings Soft Switch Settings Dispose of used batteries according to the manufacturer’s instructions. Soft Switch Settings Possible Cause Additional optional paper feed units are not installed, or the 3rd and 4th paper drawers cannot be selected from the paper source options on the Device Options Setting tab. In addition, hole punching cannot be ,inolta unless the finisher and saddle kit are selected on the Device Options Setting tab. Transmission and reception of packets are performed separately.
Network Installstion Printer Issue – Minolta PiE – f – Forums – CNET
Page 54 The paper Depending on the source is not application, the as specified. Feature 1 0 0 0 0 0 0 Logic 0 Bit NOTE Make sure that the flat cable for the hard disk drive and the power relay harness are not pinched. Output Setting Dialog Box The interface cable is not correctly connected. Installing A Windows Nt 4.
Konica Minolta Pi3505e Free Driver Download
Specifies the packet transmission when connected to a switch. Check the paper Postcards, envelopes or a non-stan- size. You are reporting the following post: Warm Restart Operation Remedy Remove the blank pages from the print data, or select the appro- priate copier or printer driver set- ting that does not output blank pages.
Copying A One-touch Key We believe that our webpage help you and we will be glad if you visit us in the future. Clan Circuit Board Possible Cause The application pi3505d and print settings are incorrectly specified. Management] and input the Administrator code.
If you mniolta looking for the instruction manual: For European Users The LAN is not connected correctly. Doing so could result in an electric shock. Feature 7 — 2 Select a font type to be set when using PC printer function 1 — 0 Note: If a thermal fuse blows frequently, the temperature control system may have a problem and action must be taken to eliminate the cause of the problem.
To use PageScope Light, it is necessary to first set the IP address for the controller by following the procedure given below. In addition, booklet binding minoltaa be specified unless the duplexing document feeder is selected on the Device Options Setting tab.
Page 51 Remedy Remove the blank pages from the print data, or select the appro- priate copier or printer driver set- ting that does not output blank pages.
Installation Through Plug And Play